GE JV566 Owner's Manual And Installation Instructions page 15

Installation Instructions
[] CONNECT DUCTWORK
TO HOOD
Use duct tape to make joints secure and air tight.
[] INSTALL LIGHT BULBS
Pro'chase and install two PAR20, 50 _ nmxinmm
halogen bulbs. I,ight bulbs are not included with
the hood.
WARNING:To ed.ce the o,e,e,t ic
shock, do not connect electrical power to the hood
without both bulbs in place.
L
[] FOLLOW ELECTRICAL CODE
Complete the electrical wiring according to
National Electrical Code and local codes.
NOTE; This hood inust be pemmnently grom_ded.
Connect house wiring (120 VAC) to hood wiring.
[] CONNECT WIRING
Cmmect house black to hood black wire, house
white to hood white wire, and house grotmd to
hood green/ye,low wire. Securely tighten the
strain relief clamp onto the house wiring.
[] REPLACE WIRING COVER
Replace the wiring coxer.
[] REPLACE FILTERS
The installation is complete. Turn on power at
serxice pane,, and test for proper operation.
TROUBLESHOOTING CHECKLIST
It the hood seems to be operating at high speed when
the control is not set on high, or if ventilation seems
inadequate, check the tollowing:
F_I /4mockouts not removed from hood.
Damper blade not opening.
Reduced airflow because the duct is too small
or the duct length is too long.
The duct is blocked.
Undersized or restrictive wall or roof cap,
15