GE Profile JVB98SH Dimension Manual

JVB98SH – GE Profile 36" Telescopic Downdraft System
™
Overall Dimensions (in inches)
36
8-1/2
7-1/2
7-1/4
27
12-1/8
C L
17-1/8
36" Unit
20-5/8
33-7/8
Installation Information: Before installing, consult installation instructions
packed with product for current dimensional data.
Specification Revised 7/11
220961
Venting Options (in inches)
Through the Floor
2-1/4
In Cabinet Discharge (Right)
6-3/8
3-1/4
In Cabinet Discharge (Down)
Note: Telescopic downdraft vents are not recommended to be installed
with cooktops that are flush mounted.
Approved for use with the following GE Profile
36" electric models, 36" gas sealed burner models and 36"
induction models.
Not approved for use with standard burner gas cooktops.
Note: The countertop must be at least 26" deep with a flat surface
area of 23-1/2" or more, front to back. In addition, other clearances
to the front edge of the countertop must be considered.
Note: Dimensions shown are for reference only. Before cutting out
countertop, refer to instructions packed with downdraft and cooktop.
In Cabinet Discharge (Left)
Note: Installation in cabinets/countertops against the wall
will not be possible in most applications. Against the wall
installations are limited to dimension requirements. Refer to
installation instructions packed with product for further details.
JXBC67 Outdoor Cover. Optional accessory may be ordered for
installation of motor and blower assembly on outside wall.
JXRB67 Indoor Remote Accessory. Optional accessory may be
ordered for installation of motor and blower assembly in an indoor
remote location.
Installation Information: Before installing, consult installation
instructions packed with product for current dimensional data.
For answers to your Monogram,
GE
®
GEAppliances.com or call
GE Answer Center
and GE cooktops –
™
Listed by
Underwriters
Laboratories
GE Profile or
® ™
appliance questions, visit our website at
service, 800.626.2000.
®