Delay Module - Zoom G2.1Nu Operation Manual

Effect Types and Parameters
ModDelay (modulation delay)
This delay effect allows the use of modulation.
PARM1
Time
Sets the delay time.
DynaDelay (dynamic delay)
This dynamic delay adjusts the volume of the effect sound according to the input signal level.
PARM1
Time
Sets the delay time.

DELAY module

This delay module allows the use of a hold function.
Delay
This long delay has a maximum length of 5000 mS.
Echo
This tape echo simulation has a long delay with a maximum length of 5000 mS.
AnalogDLY (analog delay)
This analog delay simulation has a long delay with a maximum length of 5000 mS.
PingPongD (ping-pong delay)
This ping-pong delay outputs the delay sound alternately to the left and right.
The four effect types above have the same parameters.
PARM1
Time
Sets the delay time.
46
1–2000 mS
F.B (feedback)
Adjusts the feedback amount.
Higher values cause more delay
sound repetitions.
1–2000 mS
Sense (sensitivity)
Adjusts the effect sensitivity. As
the input becomes louder, the
effect sound increases with
positive values and decreases
with negative values.
1–5000 mS
F.B (feedback)
Adjusts the feedback amount.
PARM2
0–100
PARM2
±10
PARM2
0–100
PARM3
Mix
Adjusts the amount of effected
sound that is mixed with the
original sound.
PARM3
Mix
Adjusts the amount of effected
sound that is mixed with the
original sound.
PARM3
Mix
Adjusts the amount of effected
sound that is mixed with the
original sound.
ZOOM G2Nu/G2.1Nu
0–100
0–100
0–100