Operation; Main Unit Operation - Sharp Plasmacluster FP-N40CX Operation Manual

OPERATION

MAIN UNIT OPERATION

FILTER
AUTO
DETERMINING THE BASE IMPURITY RATE
For the first 30 seconds after the power plug is inserted into the wall outlet, the unit
will check the conditions of the air. If operation is set to ON during this time, the
CLEAN-SIGN LIGHT will alternately flash in green, orange and red.
The unit will start operating when the MODE-ON / OFF Button is pressed.
To change operating modes, press the MODE-ON/OFF Button until the desired control
is activated.
AUTO operation
The fan speed is automati-
cally switched (HIGH, ME-
DIUM, SILENT) depending
on the amount of odor in the
air. The sensor detects the
odor for efficient air purifica-
tion.
SILENT operation
The unit will operate quietly
using minimal air intake.
MODE-ON/OFF Button
SILENT MED HIGH MAX POLLEN CLEAN-SIGN
Stop
OFF TIMER
Plasmacluster Indicator Light
POLLEN mode operation
The unit will operate at High fan
speed for 10 minutes, then will al-
ternate between MEDIUM and
HIGH.
10 minutes: High fan speed
20 minutes: Medium fan speed
20 minutes: High fan speed
MEDIUM to MAX operation
The unit will operate at a fan
speed of MEDIUM, HIGH or MAX.
E-12
Main Unit Controls
• AUTO
• SILENT
• MEDIUM
• HIGH
• MAX
• POLLEN
Plasmacluster