Sharp Plasmacluster FP-N40CX Operation Manual page 13

PREPARATION
2
Filter Installation
1
After the True HEPA Filter is removed
from the plastic bag, place it in the
main unit with the tabs facing up.
Do not install the filter backwards or the unit will
not operate properly.
2
After removing the Washable Active
Carbon Filter from the plastic bag,
place it on top of the True HEPA Filter
with the 2 bands located in the upper
most corners.
3
Next, place the Pre-Filter through the
2 bands located in the corners of the
Washable Active Carbon Filter.
4
Insert the tabs of the Pre-Filter into the
associated holes of the main unit.
5
Fill in the usage start date on the Date
Label, which can be found near the
upper edge of the Pre-Filter.
Use the date as a guide for the Filter Replace-
ment schedule.
Ensure the bands are uppermost
Holes in the main unit
Band
Date Label
E-11
True HEPA Filter
Tabs
Washable
Active Carbon
Filter
Pre-Filter
Tabs (4 places)