Preparation; Attaching The Stand; Inserting Batteries In The Remote Control - Sharp Plasmacluster FP-N40CX Operation Manual

PREPARATION

ATTACHING THE STAND

Please attach the stand before use.
1
Remove the Front Panel.
2
Place the unit.
• Place a soft cloth, etc., to prevent
damaging the unit.
3
Insert the tabs on the stand
into the holes on the main
unit and secure using the in-
cluded thumbscrews.
• Do not insert the thumbscrews forci-
bly or diagonally. Otherwise, the
screws may not be tightened correctly.
4
See Page E-10 for FILTER
INSTALLATION Instructions.

INSERTING BATTERIES IN THE REMOTE CONTROL

Thumbscrews
1
Remove the
back cover
Press and slide the
back cover to re-
move.
2
Insert batteries
Insert batteries with
and as shown
below.
3
Close the back
cover
E-9
1
Front Panel
2
1
Tabs Holes
Battery Information
• The batteries for this remote control are
for initial use only . Change the batteries
when necessary.
• Incorrect usage of the batteries may
cause battery fluid leakage and/or dam-
age.
Take care of the following when handling:
• When replacing the batteries, replace
both batteries with new ones of the same
type. (Use 2 AA manganese batteries.)
• When not using the unit or remote con-
trol for an extended period, remove the
batteries.
• The batteries are for initial use only and
may be depleted within 1 year.