Page 1
空氣清新機 使用說明書 “Plasmacluster” and “Device of a cluster of grapes” are trademarks of Sharp Corporation. *The number in this technology mark indicates an approximate number of ions supplied into air of 1 cm which is measured around the center of a room with the “high-density plasmacluster 7000”...
Page 2
Please read before operating your new Air Purifier The air purifier draws in room air from the air intake, passes the air through a Pre- Filter, a Active Carbon Deodorizing Filter and a HEPA Filter inside of the unit, then discharges the air through the air outlet.
Sensor Technology continuously monitors air quality, and automatically adjusting airflow based on detected air purity. Thank you for purchasing the SHARP Air Purifier. Please read this manual carefully. Before using this product, be sure to read the section: “Important Safety Instructions.”...
• Be cautious when cleaning the unit. Corrosive cleansers may damage the exterior. • Only a Sharp Authorized Service Centre should service this air purifier. Contact the nearest Service Centre for any problems, adjustments, or repairs.
Page 5
CAUTIONS CONCERNING OPERATION • Do not block the air intake and/or air outlet. • Do not use the unit near or on hot objects, such as stoves or heaters or where it may come into contact with steam. • Do not lay the unit down when using. •...
PARTS NAME FRONT DUST AND ODOR SIGN Indicates the air purity of the room in 3 levels with color changes. Green Clean PLASMACLUSTER SIGN Orange blue Plasmacluster ON Impure Plasmacluster OFF BACK Main Unit Handle Dust sensor / Air Outlet Dust Sensor Filter OFF TIMER Button / OFF TIMER indicator Light (green) HEPA Filter...
FILTER INSTALLATION Be sure to remove the power plug from the wall outlet. To maintain the quality of the filter, it is installed in the main unit and packed in plastic bag. Be sure to remove the filter from the plastic bag before using the unit. Replace the Back Panel to the Remove the Back Panel.
OPERATION CLEAN AIR START STOP • Select the desired fan speed. • Unless the power cord has been unplugged, the operation starts in the previous mode it was operated in. CLEAN ION SHOWER Releases high-density Plasmacluster ions and discharges strong air flow for 60 minutes. START NOTE •...
Page 9
OFF TIMER Select the time turning off the unit during operation. The unit automatically stops once the selected time is reached. ● 2h ● 4h ● 8h CANCEL Light Control You can turn OFF the DUST AND ODOR /PLASMACLUSTER SIGN when they are lighting up. NOTE •...
CARE AND MAINTENANCE To maintain optimum performance of this air purifier, please clean the unit including the filter periodically. Be sure to disconnect the power cord from the wall outlet before performing any maintenance. BACK PANEL (Pre-filter) Gently remove dust from the back panel by using a vacuum cleaner attachment or similar tool.
Page 11
Be sure to remove the power plug from the wall outlet. SENSORS Dust sensor 1. Remove the Back Panel. 2. Remove the Dust Sensor Filter. Dust sensor filter 3. If it is very dirty, wash it with water and dry it thoroughly.
TROUBLESHOOTING Before calling for service, please review the Troubleshooting list below, since the problem may not be a unit malfunction. SYMPTOM REMEDY (not a malfunction) Odors and smoke are not removed. • Clean or replace the filters if they appear to be heavily soiled. (Ref.
SYMPTOM REMEDY (not a malfunction) AUTO RESTART Auto Restart can be set. • Even when the plug is unplugged or the breaker is thrown during After a power failure, automatically operation, the unit resumes at the previous operation mode and resume the operation when the settings if the power recovers.
Need help?
Do you have a question about the FP-H50A and is the answer not in the manual?
Questions and answers