Listening To A Cd Or Mp3/Wma Disc; Disc Playback - Sharp DK-KP80P Operation Manual

Listening to the iPod, iPhone or iPad
(continued)
Note:
When navigating the iPod, iPhone or iPad menu with remote
control, do not operate any of the buttons on the iPod or iPhone
unit. The volume level is adjusted by pressing the VOL (+ or –)
button on the main unit or the remote control. Adjusting the
volume on the iPod, iPhone or iPad units give no effect.
iPod, iPhone and iPad operations:
The operations described below depend on the generation iPod,
iPhone and iPad you are using.
System on operation:
When the main unit is powered on, the iPod, iPhone or iPad units
will automatically power on when docked or connected in the unit.
System off (stand-by operation):
When the main unit is turned to stand-by mode, the docked iPod,
iPhone or connected iPad unit will automatically turn to stand-by
mode.
■ To disconnect iPod, iPhone or iPad
Simply remove the iPod or iPhone from the docking station
or iPad connector from USB terminal. It is safe to do so
even during playback.
Caution:
● Unplug all accessories for the iPod or iPhone before
inserting it into the docking station.
● Stop button ( ) at main unit is invalid during iPod
function.
■ Various iPod, iPhone and iPad functions
Function Main unit Remote control
Dock/USB Dock
Play
Pause
Track up/
down
Fast
forward/
reverse
____
Repeat
Shuffle
____
Menu
____
Enter
____
Cursor
Up/Down
Operation
USB
Press in the pause
mode.
Press in the
playback mode.
Press in the
playback or pause
mode.
If you press the
button in the pause
mode, press the /
button to start the
desired track.
Press and hold
down in the
playback mode.
Release the button
to resume
playback.
Press to toggle
repeat mode.
Press and hold
to toggle shuffle
mode.
Press to view the
iPod menu during
iPod function.
Press to confirm
the selection.
Press to select the
iPod menu.
E-7

Listening to a CD or MP3/WMA disc

■ Disc playback

1
Press the POWER ON/STAND-BY button to turn the power on.
2
Press the CD button on the remote control or FUNCTION
button repeatedly on the main unit to select CD function.
3
Press the OPEN/CLOSE button
to open the disc compartment.
4
Place the disc in the disc
compartment, label side front.
5
Press the OPEN/CLOSE button
to close the disc compartment.
6
Press the / (CD / ) button to start playback. After the
last track is played, the unit will stop automatically.
Caution:
● Do not place two discs in the disc compartment.
● Do not play discs of special shapes (heart, octagon, etc). It
may cause malfunctions.
● Do not push the disc compartment while it is moving.
● If the power fails while the compartment is open, wait until the
power is restored.
● If TV or radio interference occurs during CD operation, move
the unit away from the TV or radio.
● Be sure to place 8 cm (3") disc in the middle of the disc
compartment.
● Due to the structure of the disc information, it takes longer to
read an MP3/WMA disc than a normal CD (approximately 20
to 90 seconds).
Notes for CD or MP3/WMA disc:
● When the end of the last track is reached during fast forward,
"END" will appear on the display and CD operation will be
paused. When the beginning of the first track is reached
during fast reverse, the unit will enter the playback mode (only
for CD).
● Rewritable multi-session discs with unfinished writing, can
still be played.
■ Direct track search
By using the Numeric buttons, the desired tracks on the
current disc can be played.
Use the Numeric buttons on the remote control to select
the desired track while playing the selected disc.
● The Numeric buttons allow you to select up to number 9.
● When selecting number 10 or higher, use the "10+" button.