Thank you for purchasing this SHARP product. To obtain the best performance from this product, please read this manual carefully. It will guide you in operating your SHARP product. The illustrations printed in this operation manual are for the model DK-AP2.
All current and previous generation iPods with a 30 -pin connector are supplied with its own dock adaptor as standard. If you weren’t supplied or lost your dock adaptor Sharp has supplied 8 separate adaptors (refer to the table for compatible iPods), if your adaptor is not mentioned in the table please contact www.apple.com.au...
Contents Copyright may exist in material you wish to record. Copying or broadcasting such material without permission of the relevant licensees or owners of the copyright is prohibited by law. SHARP is not in a position Page General Information to authorise the copying or broadcasting of copyright materials and Precautions .
6V DC supplied with this unit as it may be damaged. Volume control SHARP is not responsible for damage due to improper use. Refer The sound level at a given volume setting depends on speaker all servicing to a SHARP authorised service centre.
System connections DK-AP2 DK-AP2(BK) Make sure to unplug the AC power lead before any connections. Connecting iPod to TV AC/DC Adaptor Cable iPod photo and 5th Generation iPod with photo and video can be viewed by connecting to TV/monitor. If the TV/monitor has a video input, connect it to the VIDEO OUT VIDEO DC IN 6V AUX IN...
DK-AP2 DK-AP2(BK) When using batteries, the brightness of all illumination light Using with the batteries (indicators) is reduced compared to using AC/DC adaptor. Replace all old batteries with new ones at the same time. Disconnect the AC/DC adaptor, and open the battery Do not mix old and new batteries.
General control Remote control (continued) DK-AP2 DK-AP2(BK) Notes concerning use: Replace the battery if the operating distance is reduced or if the operation becomes erratic. Purchase “CR 2025”, coin lithium battery. Periodically clean the transmitter on the remote control and the sensor on the unit with a soft cloth.
Listening to the iPod DK-AP2 DK-AP2(BK) Supported iPod models: iPod adaptor connection iPod nano (software 1.0 above) Choose the iPod adaptor that ﬁts your iPod. Your iPod will ﬁt snugly iPod photo (software 1.0 above) into the correct adaptor. If your iPod is not mentioned below, an iPod iPod mini (software 1.2 above) adaptor may have been included with your iPod unit.
Listening to the iPod (continued) DK-AP2 DK-AP2(BK) To insert iPod adaptor To remove iPod adaptor Insert the tip of a screwdriver (“-” type, small) into the iPod adaptor 1. Insert the iPod adaptor into unit and connect your iPod. hole as shown and lift upward to remove. iPod iPod (bottom) Dock connector...
DK-AP2 DK-AP2(BK) Various iPod functions Caution: Unplug all accessories for the iPod before inserting it into the iPod iPod operation dock. The operations described below depend on the generation iPod you are using. Function Main unit Remote Operation control Play Press in the pause mode.
Many potential problems can be resolved by the owner without calling a service technician. available lead as shown below. If something is wrong with this product, check the following before Portable audio calling your authorised SHARP dealer or service centre. player General Symptom Possible cause...
Speciﬁcations DK-AP2 DK-AP2(BK) Condensation As part of our policy of continuous improvement, SHARP reserves the right to make design and speciﬁcation changes for product Sudden temperature changes, storage or operation in an extremely improvement without prior notice. The performance speciﬁcation humid environment may cause condensation inside the cabinet or on ﬁgures indicated are nominal values of production units.