Shifting Procedures - Jeep Automobile Owner's Manual

242 STARTING AND OPERATING
speed. Additional traction and maximum pulling power
for loose, slippery road surfaces only. Do not exceed 25
mph (40 km/h).

Shifting Procedures

4 HI to 4 LOW
With the vehicle at speeds of 0 to 3 mph (0 to 5 km/h),
key ON or engine running, shift the transmission into N
(Neutral), and raise the transfer case T-handle. "The 4WD
LOW Indicator Lamp" in the instrument cluster will
begin to flash and remain on solid when the shift is
complete. Release the T-handle.
NOTE: If shift conditions/interlocks are not met, or a
transfer case motor temperature protection condition
exists, a "CHECK SHIFT PROCEDURES" message will
flash from the EVIC (Electronic Vehicle Information Cen-
ter). Refer to "Electronic Vehicle Information Center
(EVIC)" in Section 4 of this manual.
Shifter T-Handle
4 LOW to 4 HI
With the vehicle at speeds of 0 to 3 mph (0 to 5 km/h),
key ON or engine running, shift the transmission into N
(Neutral), and raise the transfer case T-handle. The "4WD