Calibration; Cleaning; Abnormal Conditions - LeCroy WavePro 7 Zi series Operator's Manual

WavePro 7Zi
You have the ability to change the oscilloscope's original factory settings via the Power Options Properties
menu in Windows under Control Panel
named Standby provides control of only the oscilloscope's computer subsystems (CPU, hard drive, etc.) and
does not affect the other subsystems within the oscilloscope. In general, these other subsystems remain fully
powered. For additional information on setting these Power Options, see the Windows Help menu or other related
technical documentation. In terms of control buttons, this oscilloscope uses only a power button/switch and
therefore references to a sleep button are not applicable.
The oscilloscope can always be placed in the Standby state (LED Off) – Power Off (except for some
housekeeping circuits) by pressing and holding in the Standby toggle switch for approximately 5 seconds.

Calibration

The recommended calibration interval is one year. Calibration should be performed by qualified personnel only.

Cleaning

Clean only the exterior of the instrument, using a damp, soft cloth. Do not use chemicals or abrasive elements.
Under no circumstances allow moisture to penetrate the instrument.
Avoid electrical shock hazard by unplugging the power cord from the AC outlet before cleaning.
WARNING - Electrical Shock Hazard
x
No operator serviceable parts inside.
x
Do not remove covers.
x
Refer servicing to qualified personnel.

Abnormal Conditions

Operate the instrument only as intended by the manufacturer.
If you suspect the oscilloscope's protection has been impaired, disconnect the power cord and secure the
instrument against any unintended operation.
The oscilloscope's protection is likely to be impaired if, for example, the instrument shows visible damage or has
been subjected to severe transport stresses.
Proper use of the instrument depends on careful reading of all instructions and labels.
WARNING
Any use of the oscilloscope in a manner not specified by the manufacturer may impair the instrument's safety
protection. The instrument and related accessories should not be directly connected to human subjects or used
for patient monitoring.
529
Power Options. It is important to note that the Windows Power Option
WP700Zi-OM-E-RevA