APRILIA Enjoy City Workshop Manual page 7

Only use GENUINE aprilia spares.
Always use the recommended lubricants and consumables.
If possible, lubricate parts before refitting them.
When tightening screws and nuts, start with the larger or the inner ones and proceed diagonally. Carry out the
tightening in successive steps before applying the full tightening torque.
Always replace self-locking nuts, seal rings, circlips, O-rings, cotter pins and screws (if the threads are damaged)
with new ones.
Clean all the mating surfaces, the oil seal rims and the gaskets before refitting them.
Apply a film of lithium grease to the oil seal rims.
Replace the oil seals and the bearings so that the mark or serial number faces outwards (side in view).
Generously lubricate the bearings before fitting them.
Check that every component has been fitted properly.
After repairing or servicing any parts, carry out preliminary checks and test the vehicle on private ground or in a
low-traffic area.
ELECTRICAL CONNECTORS
To separate two connectors, follow the procedure
described below.
Where appropriate, press down the safety hooks.
WARNING
Never pull the wires when separating two connec-
tors.
Hold the two connectors and separate them by pulling
in opposite directions.
Using a compressed air jet, carefully clean the con-
nector inside of any dirt, rust, humidity, etc.
Ensure that the wires are properly hooked on to the
terminals inside the connectors.
IMPORTANT
There is only one way to attach the
two connectors. Before attempting to join them, make
sure they are properly positioned in relation to one
another.
After joining the connectors, ensure that they are
securely fastened (a click should be heard if the
connectors have safety fasteners).
6
Release 00 2000-11
Enjoy