Table of Contents
Advertisement
A
WARNING:
Your drillshould never be connected
to power supply when you are assembling parts,
makingadjustments, installingor removing ddll
bits, cleaning, or when not in use. Disconnecting
your drill will prevent accidental starting that could
cause serious personal injury.
INSTALLING
AUXILIARY
HANDLE
ASSE M B LY
See Figure 5.
An auxiliary handle is packed with your drill for ease of
operation and to help prevent loss of control. The
handle can be rotated 360° and it can also be mounted
on the opposite side for left hand use.
Note: For convenience and ease of starting threads, the
hex nut has been trapped inside the molded slot in the
auxiliary handle.
•
Unplug your drill.
_ll
WARNING:
Failure to unplug your drillcould
result in accidental starting causing serious injury,
•
Remove auxiliary handle from plastic bag.
•
Loosen handle enough to mal_ opening large enough
to fit over chuck.
•
Slide ring of handle over chuck. Note: Handle fits on
neck of gear housing.
•
Rotate handle to desired operating position.
•
Securely tighten
by turning the auxiliary handle
clockwise.
To Adjust:
•
TO adjust, loosen
the aL_iliery handle assembly
by
turning the handle counterclockwise.
•
Rotate auxiliary handle assembly to desired operating
position.
•
Securely
tighten
by turning
the auxiliary
handle
clockwise.
CHUCK
\
TO INSTALL BITS
See Figures 6 and 7.
•
Unplug your drill.
CHUCK BODY
DRILLBIT
CHUCK JAWS
CHUCK COLLAR
RIGHT
Fig. 6
_1
WARNING: Failure to unplug your drillcould
result in accidental starting causing serious injury,
•
Open or close the chuck jaws to a point where the
opening is slightly larger than the drill bit you intend
to use. Also, raise the front of your drill slightly to
keep the drill bit from falling out of the chuck jaws.
•
Insert drill bit into chuck the full length of the jaws.
_1= WARNING:
Do not insert drill bit into chuckjaws
and tighten as shown in figure 7. This could cause
ddll bit to be thrown from your ddll resulting in
possibleserious personal injuryor damage to your
chuck.
Fig. 7
• Tighten chuck jaws securely using the chuck key
provided. DO NOT use a wrench to tighten or loosen
the chuck jaws.
•
Remove chuck key and return to storage area.
AUXIUARY HANDLE
ASSEMBLY
Fig, 5
8
Advertisement
Table of Contents
