Craftsman Mow-N-Vac 486.24505 Owner's Manual page 17

FOi:i 990 AND NEWER MURRAY
TRACTORSWITH A 46" DECK
Tape 46" template onto deck adapter, Mark and then
cut out adapter,
Fasten the angle bracket and the mounting bracket to
the mower deck as shown in figure 32. Use two 5/16"
x 3/4" carriage bolts, 5/16" flat washers and 5/16".
lock nuts. The bolt heads go on inside of mower
deck,
Drill two 5/16" diameter holes in the deck adapter that
will align with the holes in the angle bracket and the
mounting bracket. Assemble the deck adapter to both
brackets using two 1/4" x 3/4" hex bolts, 1/4" fiat "
washers, nylon washers and 1/4" lock nuts. Se_ -
figure 32.
\ \.
ANGLE BRACKET ,1/4',
NYLON WASHER XXX_
1/4" FLAT
1/4" x 314"
\
NYLON WASHER.
114" x 3/4" HEX BOLl
FIGURE 32
Assemble end of hose and hose clamp over the round
opening of deck adapter and tighten clamp. GO
DIRECTLY TO THE OPERATION INSTRUCTIONS
WHICH ARE LOCATED ON PAGE 18.
17