Advertisement
STEP 3:
(SEE FIGURE 3)
*
Tighten all hex nuts and bolts, following the same
sequence as assembled in steps 4, 5 and 6. Do not
collapse tube when tightening.
*
Assemble a spacer and then a 1/2" fiat washer onto
each end of the axle.
STEP 5:
(SEE FIGURE 5)
•
Place the drive wheel onto the end of the axle that
has an indent. The long end of the hub goes to the
inside.
Place a hub cap onto the end of the axle. Using a
small hammer, lightly tap the hub cap until it is snug
against the wheel.
AXLE
SPACER
FIGURE
3
112" DIA.
FLAT WASHER
HUB CAP
FIGURE 5
STEP 4: (SEE FIGURE
4)
Place the wheel (long end of hub first) onto the end of
the axle that has no indents.
10. Place a 1/2" fiat washer onto the axle and then
lightly tap a hub cap onto the axle until it is snug
against the washer and wheel hub.
END WITH NO
CROSS HOLE
112"FLAT
WASHER
HUB CAP
FIGURE 4
STEP 6: (SEE FIGURE
6)
*
in order to assemble the hitch bracket to the hitch
tube, turn the spreader upright on its wheels.
Assemble the bracket to the top of the hitch using two
1/4" x 1" hex bolts and 1/4" nylock nuts.
HITCH
PIN
HAIR COTTER PIN
FIGURE 6
Call 1-866-576-8388
for missing parts or assembly help
5
DO NOT RETURN TO STORE
Advertisement
