Advertisement
STEP 4:
(SEE FIGURE 4)
*
Assemble a spacer (I), a 3/4" fiat washer (G), a wheel
(air valve facing out) and another 3/4" fiat washer (G)
onto the end of the axle that has both the large and
small holes.
=
install a 1/8" x 1-1/2" cotter pin (E) into the small hole
in the end of the axle.
*
Open the bail on the drive pin (J) and install it through
the wheel and the large hole in the axle. Close the
bail to lock the pin in place.
(J) DRIVE PiN
k
(E) 1/8" x 1-1/2"
X_
COTTER PIN
(I) SPACER
(G) 3/4" FLAT
WASHER
FIGURE 4
STEP 6:
(SEE FIGURE 6)
,
insert the hook end of the flow control rod through
the hole in the slide gate bracket located under the
hopper.
HOPPER
SLIDE
GATE
BRACKET
J
FLOW
CONTROL
ROD
FIGURE 6
STEP 7:
(SEE FIGURE 7)
*
Assemble the flow control mounting tube to the hitch
tube using two 5/16"x 1-3/4" hex bolts (A) and 5/16"
nylock hex nuts (D). DO NOT TIGHTEN YET.
STEP 5: (SEE FIGURE
5)
*
Turn the spreader upright on its wheels.
*
insert the pinched end of the flow control rod through
the hole in the in the flow control arm.
FLOW
CONTROL
ROD
/
FIGURE 5
FLOW CONTROL
MOUNTING TUBE
(A) 5/16" × 1-3/4"
HEX BOLT
FIGURE 7
Call 1-866-576-8388
for missing parts or assembly help
5
DO NOT RETURN TO STORE
Advertisement
