Advertisement
STEP 7:
(SEE FIGURE 7)
*
Assemble the flow control link (end with small hole) to
the flow control arm using a 1/4" x 1" hex bolt, a nylon
washer and a 1/4" nylock nut. Tighten carefully. The
flow control link should not be loose but should pivot
with no more than slight resistance.
STEP 9: (SEE FIGURE
9)
*
Place a 5/16" fiat washer onto the end of the flow
control rod. insert the end of the rod through the slot
in the flow control mounting bracket and through the
hole in the flow control link. Secure with a 3/32" x 3/4"
cotter pin.
FLOW CONTROL
LINK
FLOW
CONTROL
ARM
SMALLEST
HOLE
NYLON
WASHER
FIGURE 7
1/4" NYLOCK
NUT
/
STEP 8:
(SEE FIGURE 8)
•
Assemble the flow control arm to the flow control
mounting bracket using a 1/4" x 1" hex bolt, two nylon
washers and a 1/4" nylock nut. Tighten carefully.
The flow control arm should be snug, but should pivot
with no more than a slight resistance.
•
Assemble the vinyl grip.
VINYL GRIP
FLOW
CONTROL
ARM
FLOW CONTROL
MOUNTING
BRACKET
1/4" x 1"
HEX BOLT
\
FIGURE 8
6
(2) NYLON
WASHERS
1/4"NYLOCK
NUT
_16"FLAT
WASHER
3/32"
COTTER
PIN
FLOW
CONTROL
ROD
FIGURE 9
SLOT
FLOW
CONTROL
LINK
STEP 10:
(SEE FIGURE 10)
*
Hook free end of flow control rod through hole in slide
gate bracket located near the bottom of the hopper.
/
SMDE GATE
BRACKET
HOPPER
FLOW CONTROL
ROD
FIGURE
10
Call 1-866-576-8388
for missing parts or assembly help
DO NOT RETURN TO STORE
Advertisement
