Reversing The Door Swing - GE GTH18DBPARCC Owner's Manual And Installation Instructions

Installation Instructions
[] PLUG IN THE REFRIGERATOR
Arrange the coil of tubing so that it does not vibrate
against the back of the refi'igerator or against the
wall. Push the refrigerator back to the wall.
START THE ICEMAKER
On power switch models, set the icemaker power
switch to tile /(0n) position. On feeler arm models,
move the feeler arm to the ON (down) position. The
icemaker will not begin m operate until it reaches
its operating temperature of 15°F (-9°C) or below.
It will then begin operation automatically.
Power s witchmodel
in the
STOP(up)position
r Arm in
the ON (down}position
Feelerarm model
NOTE: In lower water pressure conditions, the
water valve may turn on up to 3 times to deliver
enough water to the icemaker.
REVERSING THE DOOR SWING
IMPORTANT NOTES
When reversing the door swing:
• Read the instructions all the way through before
starting.
• Handle parts carefully to avoid scratching paint.
• Set screws down by their related parts to avoid using
them in the wrong places.
• Prmdde a non-scratching work surface for
the doors.
IMPORTANT: Once you begin, do not move tile
cabinet undl door-s,Mng reversal is completed.
These instructions are for changing the hinges from
tile right side to tile left side--if you ever want to change
tile hinges back to the right side, follow these same
instructions and reverse all references to left and right.
Unplug the refrigerator from its electrical outlet.
Empty all door shelves, including the dairy
compartment.
TOOLS YOU WILL NEED
Phillipsscrewdriver
3/8" Headsocket driver
{a 6-pointsocketis
recommended}
Maskingtape
Puttyknife or
thin-bladescrewdriver
T20or T25Torx ®
driver,whicheveryour
model requires
19