GE GTH18DBPARCC Owner's Manual And Installation Instructions page 21

Installation Instructions
[] TRANSFER BOTTOM HINGE
BRACKET TO THE LEFT
For models with a base grille, remove it by grasping it
about 6" from each end and pulling its bottom edge
toward you.
Using a Torx ®drivm; move tile bottom hinge bracket
and plastic washer from tile right side to tile left side.
NOTE: If tile washer is not on the hinge bracket,
check to see if it is stuck to tile bottom oftbe door.
Hinge B racke
For models with a base grille, before replacing tile
base grille, remove tile grille cap by removing tile
screw. Screw tile cap to the opposite side.
Replace tile base grille by inserting the tops of tile
metal clips into the owal vents, making sure one of the
plasdc tabs on tile back oftbe grille goes into each of
tile oven vents. Then push tile bottom of tile grille
forward until it snaps into place.
[] TRANSFER CENTER HINGE
BRACKET TO THE LEFT
Remove tile center hinge bracket by removing tile
three Torx ®screws.
NOTE: Keep these screws witb tile hinge bracket.
They are long .screws and will be used when installing
tile hinge on tile otber side.
On .some models, you will need to remove tile color-
matched caps from tile screw heads |;,efbre you can
remove tile screws. Use tile edge of a thin fiat blade to
gently p_7¢ tile caps off tile screw heads. (A putvy knifi_
works well fbr tbis.) Cover tile blade witb rape to
prevent scratching tile paint.
Remove the three Torx ®screws from tile center lef}
side of the cabinet. Screw them into the holes on
the right side.
Place tile center hinge bracket over tile holes at
the center left side of the cabinet, lnsert and
tighten the three long screws.
Replace the caps by snapping tbem over the screws
with your fingm:
, _ Screw Cap
[] TRANSFER DOOR STOPS
On each door, move tile metal door stop from tile
right to the left.
Move any screws from the left to tile right.
DoorSto
LeftSide RightSide
21