Replacing The Light Bulbs - GE GTH18DBPARCC Owner's Manual And Installation Instructions

ww_.GEAppliances.com
Preparing for Vacation
For long vacations or absences, remove
food and unplug the refrigerator. Move
the refrigerator control to the O(off)position
and clean the interior with a baking soda
solution of one tablespoon (15 ml) of
baking soda m one quart (1 liter) of water.
Leave the doors open.
Set the icemaker power switch to the O (Off)
position or move the feeler arm to the
STOP (up) position (depending on model)
and shut offthe water supply to the
refrigeratoi:
If the temperature can drop below freezing,
have a qualified smMcer drain the water
supply system (on some models) to prevent
serious property damage due to flooding.
Preparing to Move
Secure all loose items such as grille,
shelves and drawers by taping them
securely in place to prevent damage.
Be sure the refrigerator stays in an uprightposition
during m oving.
Replacing the light bulbs.
Setting either or both controls to 0 (off) does not remove power to the light circuit.
Some models have only one light
Refrigerator Compartment--Upper Light
A CAUTlON:Light u/hs may e/,et. 0
Replace with an appliance
bulb o f
the same or lower wattage.
Unplug the refrigerator. _ Plug the refrigerator back in.
The bulbs are located at the top of the
compartment near the opening.
!)TUTUTUTUTUTUTUTUTUTUTUTUTUTUTUTUTUTUTUTU
Freezer Compartment Dome Light (on some models)
A CAUTlON:Light u/hsmay ehot.
Unplug the refrigerator.
The bulb is located behind a light
shield at the back of"the freezer
compartmenL To remove, squeeze
the top and tx_ttom of the shield and
pull the shield off.
After replacing with an appliance bulb
of the same or lower wattage, replace
the shield.
Plug the refrigerator back in.
13