Alternate Mounting Method - Craftsman 113.226423 Owner's Manual

assembly
7. If you prefer to mount your sander to a leg set we
recommend the leg set for bench top tools which is
available through Sears Retail or Catalog Stores,
The number of this leg set is 9-22244. This leg set
is an optional accessory and instructions to mount
the belt and disc sander to this leg set are included
in the leg set package.
ALTERNATE MOUNTING METHOD
An alternate method of mounting the belt and disc san-
der is to fasten the sander to a mounting board. The
board should be of sufficient size to avoid tipping of
sander while in use. Any good grade of plywood or
ch_pboard with a 3/4" minimum thickness is recom-
mended. (Thinner chipboard can break.)
1, Follow instructions for mounting sander to work-
bench, substituting a board 18" X 24" minimum size
in place of the workbench.
t
[
18"
24'
MOUNTING BOARD
/
MOUNTING HOLES
2,
BELTAND DISCSANDER
5/!6" HEXNUT.Nk_k_._.,"
::::: :::::: \' Y
Substitute 5/16" flat head bolts for mounting boits "_,_'_:_===1
(NOT INCLUDED). Bolt length should be 1-1/2 plus _'_
the thickness of the mounting board. I ! 1 i
, , I , ", ,"
NOTE:
For proper stability, holes must be counter /" i ",
sunk so screw heads are flush with the bottom sur- /' , .J ] _.,
face of the mounting board.
COUNTERSINK T HEAREA
AROUND EACH HOLE SO BOLT
HEADWILLNOTPROTRUDE
BELOWBOl-fOM SURFACE
OF MOUNTING BOARD.
1_2"FOAM PAD OPTIONAL
/
/
\
MOUNTING BOARD
5;t6" FLATHEADBOLT