Craftsman 113.226423 Owner's Manual page 21

trouble
shooting
WARNING: For your own safety, turn switch "OFF'"
and remove plug from power source outlet before
trouble shooting your sander,
TROUBLE
,.,,,,, ,,,J ,,
Motor will not run,
Machine slows down
when sanding.
Sanding Belt runs
off pulleys.
Wood burns while
sanding,
PROBABLE CAUSE
, , ,, i , ,,,,,.,IL i,,, ,,,,,,, .,
1. Defective On-Off switch.
Defective switch cord.
Defective switch box.
2. Burnedout motor. 2.
I. Timing belttootight.
2. Applying too much pressure to
workpiece.
1. Nottracking properly.
1. Sanding disc or belt is
glazed with sap.
REMEDY
, ,L , '",",,,.'_ ,,, .....
1. Replace defective parts before using
belt and disc sander again.
Consult Sears Service. Any attempt
to repair this motor may create a
HAZARD untess repair is done by a
qualified service technician. Repair
service is available at your nearest
Sears Store.
1. Decrease belt tension, see
Assembly Section.
2. Ease up on pressure.
Adjust tracking, see Assembly
Section, "Replacing the Sanding
Belt -- Tensioning and Tracking"
1. Replace disc or belt.
,,,,,, ,,,,, i n l i -
RECOMMENDED ACCESSORIES
ITEM CAT. NO.
Miter Gauge ........................ 9--24214
Sanding Belts and Discs ............ See Catalog
Leg Set ............................ 9--22244
The above recommended accessories are current and
were available at the time this manual was printed.
2t