Table of Contents
Advertisement
assembly
MOUNTING BELT AND DISC SANDER
TO WORKBENCH
If belt and disc sander is to be used in a permanent
location, it should be fastened securely to a firm sup-
porting surface such as a workbench. A 5/16" bolt, flat-
washer, Iockwasher, and hex nut (not included) should
be used at each mounting hole to secure the belt disc
sander to the workbench.
If mounting
to a workbench,
holes
should
be drilled
through
supporting
surface
of the workbench
as follows:
1. Set the belt disc sander
on the workbench
in the
exact position
where
it is to be mounted,
2, Push a pencil through
one of the mounting
holes
and place a mark on the workbench
that marks the
center
of the mounting
hole opening.
Mark the other
three mounting
hotes using the same
method.
SPECIAL
NOTE:
Make sure the pencil
marks are
placed
very near the center
of the mounting
hole
openings,
WARNING:
Check
under workbench
before
drilling
holes
to make
sure
electrical
wires,
gas pipes,
etc.,
will not be hit by drill
bit.
3. Remove
the belt disc sander
from the workbench.
Drill four 3/8" diameter
holes using the pencil marks
as the center
of the drilled
holes.
SPECIAL NOTE:
It is highly recommended that you
place a soft foam pad between your belt disc sander
and workbench. The use of this pad will reduce noise
and vibration.
4. Place the belt disc sander back on the workbench.
Align the mounting holes in the sander with the
drilled holes in the workbench.
MOUNTING HOLES
.
6,
Insert four 5/16" bolts through the mounting holes
and through the dritled holes in the workbench.
Place a 5/16" flat washer, 5116" lockwasher,
and a
5/16" hex nut on the bolt and tighten,
SPECIAL
NOTE: Do
not overtighten
mounting
bolts - leave some cushion in the foam pad for ab-
sorbing noise and vibration.
BELT AND DISC SANDER
I!2' FOA_ PAD
X,X_.
J
/OPTIONAL
/
,
i
WORKBENCH
Hide quick links:
Advertisement
Table of Contents
