Bevel Sanding; Positioning Belt Table - Craftsman 113.226423 Owner's Manual

basic operation
BEVEL SANDING
_The worktable can be tilted from 0 ° - 45 ° for bevel
sanding. Loosen the table lock knob and tilt the work-
table to desired angle as shown.
WARNING: To avoid trapping the work or fingers
between the table and sanding surface, the table
should be repositioned on the table support rod to
retain a maximum of 1!16-inch distance between
disc and table.
TABLE
SUPPORT RO0
POSITIONING BELT TABLE
Two bett table locking bolts lock the belt tabte in a
vertical or horizontal position,
To adjust vertical position:
a, Remove the backstop.
b, Loosen the two belt table locking bolts using a 1/2-
inch wrench.
BELT TABLE __..,,..
WRENCH _C_.,p_ G a_l T_
Y
% .
J
,,,,,.,=,'= I ii '1 1,1,11 i , i,lU ,i,_rrll I tl I I................ It Ul,l,,,= J=
c. Position belt tabei vertically as shown and tighten
the two bolts.
t7