Craftsman 113.226423 Owner's Manual page 13

7. To adjust table so it is parallel to sanding surface,
locate two allen head set screws on bottom side of
the table,
8. Loosen these two set screws and position the table
parallel to the sanding surface. (There should be a
minimum gap of 1/16" across the full face of the
sanding surface,)
9, Tighten set screws,
VIEW SHOWING
UNDERSIDE OF TABLE
ALLEN HEAD
10. There is an auxiliary mounting hole in the base.
This is for mounting the table when the belt is used
in a vertical position by moving the complete rod/
worktable assembly and table positioning bolt_
Note and follow the above WARNING for table
clearance,
AUXILIARY
MOUNTING
HOLE
TABLE
POSITIONING BOLT
TABLE ASSEMBLY
LOCK KNOB
iii
SQUARING TABLE ASSEMBLY
WARNING: To avoid injury from accidental start,
make sure t0ol is unplugged before aligning.
1, Using a combination square, check the angle of the
worktable with the disc.
NOTE: The combination square must be "true" --
See start of assembly section on Pg, 6 for checking
method,
2. If the table is not 90 ° with the disc •., loosen table
lock knob screw and tilt table.
3, Adjust worktable square to the disc and retighten
table lock knob.
4, Adjust pointer to 0° mark on trunnion with phillips
screwdriver if necessary. TABLE
POSmONtNG
BOLT
/
I
TABLE
LOCK :KNOB
TRUNNION
13