Miter Gauge - Craftsman 113.226423 Owner's Manual

,_SANDING CURVED EDGES
DURVED EDGES
Sand inside curves on the idler pultey,
Sand outside curves on the sanding disc.
, i,,1[ !ll,ii ,, , ............... ii ii, ...................... [ ,i, __ !l
MITERGAUGE
SANDING SMALL END SURFACES ON THE
SANDING DISC
Move the work across the center to the left side of the
face of the sanding disc. For accuracy, use a miter
gauge (accessory).
i,iii ,
COMBINATION S QUARE
NOTE: Use a combination square to square the miter
gauge to the face of the disc (combination square must
be "true" -- See Start of Assembly section on page 6
for checking method). If it is not square, loosen the
miter gauge knob and move the miter gauge slightly
until it is square. Without moving the miter gauge,
tighten the knob securely.
I
19