Craftsman 315.222560 Owner's Manual page 8

SWITCH
See Figure 2.
To turn your drill ON. depress the switchtdgger. To
turn it OFF, release the switch trigger.
cENTERPOSITION SELECTOR
(LOCK_
TO INSTALL BATrERY PACK
• Lock switch tdgger on your drillby placingthe
directionof rotation selector in center position,
See Fkjum 5.
• Place battery pack in your ddll, Align raised rib
inside ddll with groove on battery pack,
See Figure 4.
SWITCH
TRIGGER Fig. 2
VAR_BLE SPEED
Thistool hasa variable speed switch that delivershigher
speedand torquewithincreasedtdgger pressure.Speed
iscontrolledbythe amountof switchtriggerdepression.
Note: You might hear a whistling or dnging noise from
the switchduring use. Do not be concemed, this isa
normal part of the switch function,
TWO-SPEED GEAR TRAIN
See Figure 3.
Your drill has a two-speed geer train designed for
ddningor driving at HI or LO speeds. A slide switch is
locatedon top of your ddll to select either HI or LO
speed. When using drill in the HI speed range, speed
will increase and unitwill have less power and torque.
When using drill in the LO speed range, speed will
decrease and unitwill have more power and torque.
Use HI speed for fast drillingor drivingapplications
and LO speed for high power and torque applications.
TWOSPEED
LOSPEED GEAR TRAIN(HI-LO)
HI SPEED
Fig, 3
BAITERYPACK
LATCHES
DEPRESS LATCHES T O
RELEASE BATTERY PACK Fig. 4
• Make sure the latches on each side of your battery
pack snap into place and battery pack is secured in
drillbafom beginning operation.
A CAUTION: When placing battery pack in your
drill, be sure raised db inside ddll alignswith
groove on battery pack and latches snap in place
properly.Improper assembly of battery pack can
cause damage to internalcomponents,
TO REMOVEBATrERYPACK
• Lock switch trigger on your drill by placingthe
directionof rotationselector in center position,
See Figure 5.
• Locate latches on end of battery pack and depress
to release battery pack from your drill.
See Figure 4.
II Remove battery pack from your drill.