WARNING: A lways w earsafety g oggles o r
safety glasses w ithsideshields w hen operating
tools. F ailure t o dosocould result i nobjects
being thrown intoyour
eyes, resulting in possible
sedous injury.
_lb WARNING:
Do not allow familJadtywith your
drill-ddverto make you careless. Remember that
a careless fraction of a secondis sufficientto
inflictsevere injury.
CHARGING
BA'I-rERY PACK
The battery pack for this tool has been shippedin a
low charge conditionto prevent possible problems,
Therefore, you shouldcharge it until lighton front of
charger changes from red to green.
Note: Batteries will not reach full charge the first time
they are charged. Allow several cycles (ddlling
followed by recharging) for them to become fully
charged.
TO CHARGE
• Charge battery pack only with the charger
provided,
• Make sure power supply is normal household
voltage, 120 volts, 60 Ha, AC only.
• Connect charger to power supply.
•
Place battery pack in charger aligning raised db in
charger with groove in battery pack.
•
Press down on battery pack to be sure contactson
battery pack engage propady with charger
contacts.
• Normally, the yellow and green lights on charger
will come on. This indicates charger is in soft start
mode end shouldswitch to fast charge mode within
5 minutes.When charger is in fast charge mode
the red lightwill come on. If after a period of 15
minutesthe yellow and green lights remain on,
remove battery pack, wait 1 minuteand reinsert
battery pack in charger. If the yellow and green
lightscontinueto remain on after an additional 15
minutes, the bettery pack is damaged and will not
accept a charge. Return battery packto your
nearest Seers Repair Center for checking or
replacing.
•
When your battery pack becomes fully charged, the
red lightwill turn OFF and the green light willturn
ON.
•
After normal usage, 1 hour of chargingtime is
required to be fullycharged, A minimumcharge
time of 1-1/2 hours is required to recharge a
completely dischargedtool.
• The battery pack will become slightlywarm to the
touchwhile charging.This is normal and does not
indicatea problem.
•
Do not place charger in an area of extreme heat or
cold. It willwork best at normal roomtemperature.
• When bettedes become fully charged, unplug
chorger from power supply and remove the battery
pack.
LED FUNCTION
OF CHARGER
LED WILL BE LIGHTED TO INDICATE STATUS OF CHARGER AND BA3"FERYPACK:
•
Red LED Lighted-- Fast Charging Mode.
•
Green LED Lighted= Slow Charging Mode and Fully Charged BatteP/Pack.
•
Yellow and Green LED Lighted= Soft Start Mode, orAfter 1/2 Hour Equals Hot or Defective
Battery Pack.
7