Installing The Zoneline - GE AZ38H12DABM2 Owner's Manual And Installation Instructions

installation instructions
INSTALLING THE ZONELINE
[] iNSTALL THE WALL CASE AND
EXTERIOR GRILLE
The I_B71 series or IL_B77 _<dl case must be
properl) installed per instructions packed with
tile case.
* Remoxe tile conugated stittbner and tile outdoor
protectix e panel, Llse tile slit in tile outdoor panel
as a handhokl and push out.
Pro
panel
Stiffenel
• Install the extel_ior grille from tile room side
following instructions packed with tile gl-ille.
Insulated Wall Case
This unit is designed to be installed in a GE plastic
or an insulated steel wall case. This minimizes
condesisation fix)l// iksIs//illg (511
tile
1"(5(5I//
skle ot
tile case.
The ]gkg71 selJes wall cases are insulated. Insulation
kit lgM_5,)01I, is ax;filable tbr use with lgkg77 or
e_sting uninsulated wall cases when needed.
NOTE: For installation with a subbase or duct adapte_;
see the instructions packed with those kits.
[] PREPARE THE UNIT
• Carefully remove shipping tape and loam shipping
blocks fl'om tile room cabinet, compressor and
vent do(m There may be multiple blocks and pieces
ot shipping tape that need to be reinoved.
Shipping tape
(Locations m ayvary)
• Remove tile room cabinet b)pulling it out at tile
bottom to release it (l), then lift it up to clear tile
rail along tile trait top (2).
• If vent door is t(5 be operational, rem(sve shipping
screws ti'om tile fl'(mt side of tile xent d(55)_; if" present.
Remove two
shipping screws
18