Air Direction; Controls; To Remo_E The Room Cabinet; Vent Control - GE AZ38H12DABM2 Owner's Manual And Installation Instructions

Otherfeatures of yourZoneline.
Ventilation Control
The xentilation control lexer is located at the
upper lett side of the Zoneline unit, behind
the room cabinet.
_,_q_en set at the closed position, onE' the air
inside the room is circulated and filtered.
X,_]_en set at the open position, some outdoor
air will be drawn into the room. This will
reduce the heating or cooling efficiency.
Energy Tip: Kee I) the vent control at the closed
position. The room air will be filtered and
circulated.
NOTE:Two shiww screws mustbe removed fromthe
ventdoorbeforeuse.Seethe/nstal/afion Instructions
in thebackof thismanual
Open
position
Vent
control Closed
(shownin position
middle
position)
ToRemovethe RoomCabinet
Additional controls are located behind the
I'OOIll
cabinet.
To remove:Pull out at the bottom to release it
fl'om the tabs (l). Then lift up (_2).
To replace: Place the tabs oxer the top rail ( l ).
Push imvard at the bottom tmtil it snaps into
place (2).
Air Direction
To a(!iust the air direction, remove the room
cabinet. Remove the 7 louver screws that hold
the louver insert in place. Flip the louver insert
180°, replace the screws and the room cabinet.
Louverscrews
Remove the room cabinet and flip the louver
insert to change the air direction.
Louverscrews
4