Download Print this page

Craftsman 315.101531 Operator's Manual page 10

3/8 in. 14.4 volt cordless right angle drill-driver variable speed / reversible

Advertisement

SWITCH
See Figure 2.
To turn the drill ON, depress the switch trigger. To turn it
OFF, release the switch trigger.
_i
WARNING:
Always wear safety goggles or safety
glasses with side shields when operating tools.
Failure to do so could result in objects being thrown
into your eyes, resulting in possible serious injury.
FORWARD
FORWARD/REVERSE
SELECTOR W_H
CENTERLOCK
POSITION
REVERSE
REVERSIBLE
See Figure 2.
This direction of rotation is reversible and is controlled by
a selector located above the switch trigger. With the drill
held in normal operating position, the direction of rotation
selector should be positioned to the left of the switch for
drilling. The drilling direction is reversed when the selector
is to the right of the switch. When the selector is in center
position, the switch trigger is locked.
CAUTION:
To prevent gear damage, always allow
chuck to come to a complete stop before changing
the direction of rotation.
To stop, release switch trigger and allow the chuck to come
to a complete stop.
KEYLESS
CHUCK
See Figure 3.
The drill has a keyless chuck. As the name implies, you can
hand tighten or release drill bits in the chuck jaws. Grasp
and hold the collar of the chuck with one hand. Rotate the
chuck body with your other hand. The arrows on the chuck
indicate which direction to rotate the chuck body in order to
LOCK (tighten) or UNLOCK (release) the drill bit.
VARIABLE
SPEEDSWITCH
TRIGGER
Fig. 2
SWITCH
LOCK
See Figure 2.
The switch trigger can be locked in the OFF position. This
feature can be used to prevent the possibility of accidental
starting when not in use. To lock the switch trigger, place
the direction of rotation selector (Forward/Reverse
Selector) in the center position.
Note: When the selector is in center position, the switch
trigger is locked.
_t
WARNING:
Battery tools are always in operating
condition. Therefore, switch should always be locked
when not in use or carrying at your side.
VARIABLE
SPEED
This toot has a variable speed switch that delivers higher
speed and torque with increased trigger pressure. Speed is
controlled by the amount of switch trigger depression.
Note: You might hear a whistling or ringing noise from the
switch during use. Do not be concerned; this is a normal
part of the switch function.
UNLOCK
CHUCK
(RELEASE)
COLLAR
DRILLBIT
CHUCK
BODY
LOCK
(TIGHTEN)
Fig. 3
_
WARNING:
Do not hold the chuck body with one
hand and use the power of the drill to tighten the
chuck jaws on the drill bit. The chuck body could slip
in your hand or your hand could slip and come in
contact with rotating drill bit. This could cause an
accident resulting in serious personal injury.
10

Advertisement

loading