Craftsman 152.229020 Instruction Manual page 23

CHANGmNG MOTOR VOLTAGE
MAKE CERTAIN to disconnected the machine from the
power source before working on motor.
Have a certified eUectrbian make aft eUectrbaUconnec-
tions. Aft UocaU and state codes must be maintained.
The motor supplied with the DrHUPress is a duaUvoUtage
120/240°voUt, singb phase motor. The motor is wired
from the factory for 120°voUtoperation. To change to
240°voUtoperation, proceed with the foflowing instruc-
tions, it is aUsonecessary to repUace the 120 voUtpUug,
suppfied with your machine, with a UL/CSA Listed pUug
(not included) suitable for 240 volts and the rated cur-
rent of the motor. The motor with a 240 volt plug
should only be connected to an outlet having the same
configuration as the plug. No adapter is available or
should be used with the 240 volt plug.
1, Make sure switch is OFF and disconnect power
cord from power source,
2. Verify on the motor tag that motor is dual voltage.
3. if motor tag states that it is dual voltage remove
junction box cover on motor.
4, Using wiring diagram on inside of junction box
cover, reconnect motor leads for 240°volt operation,
5. Replace junction box cover.
6. Replace 120 volt plug with a UL/CSA Listed 240
volt plug rated for current of the motor.
7. The ON/OFF switch is a 4-pole switch and does not
need any modifications.
Turn the power switch OFF and unplug the power cord
from its power source,
The drift press has sealed lubricated bearings in the
motor housing that do not require any additional lubrica-
tion from the operator,
The quill and spindle assemblies should be periodically
lubricated, Lower the quill assembly and squirt or wipe
a thin film of lightweight machine oil on the entire sur-
face, Place a few drops of light machine oil down the
spindle assembly, Raise and lower the quill several
times to distribute the oil evenly,
With the drift press unplugged, blow off motor with low°
pressure air to remove dust or dirt, Air pressure above
50 P, S, I, should not be used as high-pressured air
may damage insulation, The operator should always
wear eye protection when using compressed air,
Do not use a shop vacuum to clean metal shavings.
The metal shavings can cause an explosion or fire.
Do not allow chips and dust to accumulate under drift
press, Keep area clean and in safe order,
CAUTION: DO NOT USE FLAMMABLE MATERIALS
to clean the drift press.
After cleaning, apply a good quality automotive wax to
any unpainted surfaces, Make sure to buff out the wax
before assembly,
ONLY trained personnel should perform repairs to the
drill press, Contact your nearest Sears Service Center
for authorized service, Unauthorized repairs or replace°
ment with non-factory parts could cause serious injury
to the operator and damage to the drift press,
23