Craftsman 152.229020 Instruction Manual page 11

UNPACKUNG AND CHECKUNG CONTENTS
This drHU press wHU require some amount of assemMy,
Remove aH of the parts from the shipping box and Uay
them on a clean work surface,
Remove any protective materiab and coatings from aH
of the parts and the drHU press, The protective coatings
can be removed by spraying WD°40 on them and wip-
ing it off with a soft cloth, This may need redone severaU
times before aH of the protective coatings are removed
compbteUy, CAUTION: DO NOT use acetone, gasoline
or Uacquer thinner to remove any protective coatings on
your drHU press,
After cleaning, apply a good quality automotive wax to
any unpainted surfaces, Make sure to buff out the wax
before assembly,
Compare the items to figures below; verify that all items
are accounted for before discarding the shipping box,
if there are any missing parts, call Customer Helpline
1 °800°897°7709,
The drill press is a heavy machine, two people may
be required to unpack and lift machine,
if any parts are missing, do not attempt to plug in the
power cord and turn ON the drill press, The drill press
can only be turned ON after all the parts have been
obtained and installed correctly,
Figure 3-1
A
C
D
rq
E
A, Drill press head and motor assembly
B, Table
C, Light assembly
D, Base
E, Column, rack and ring
11