Craftsman 152.229020 Instruction Manual page 22

QUILL LOCK
The quill allows the up and down movement of the
chuck, Different setup or working operation may
require the quill to be lower and locked into position,
Figure 18-1
C
B
A
Lower quill (A) to desired depth and tighten quill locking
handle (B), The quill locking handle is spring loaded
and can be repositioned by pulling out on the hub (C)
and rotating it, See Figure 18-1,
To unlock the quill, hold onto the feed handle and
loosen the quill locking handle, The quill is spring
loaded and wiii return back up into the drill press head
casting, Be sure to hold onto the feed handle to control
the speed in which the quill returns,
CORRECT DRULUNG SPEEDS
Factors that determine the correct speed are: the work-
piece, the size of the hob, the type of bit or other cutter,
and the quality of cut wanted,
Use the recommended speed for the drill bit and work-
piece,
DRULUNG WOOD
Twist drill bits, usually intended for metal drilling, can
also be used for boring hobs in wood, However, brad
point or Forstner bits are generally preferred for working
in wood, These bits cut a fiat bottom hob and are
designed for removal of wood chips, Do not use hand
bits which have a screw tip or auger bits, At drill press
speeds, they will lift and rotate the workpiece,
For through boring, align the table so that the bit will go
through the center hob, Scribe a vertical line on the
front of the column and a matching mark on the table
bracket and the drill press head, so that the table and
drill press head can be clamped in the center position
at any height,
Feed the bit slowly when it is close to cutting through
the wood to prevent splintering the bottom face, Use a
scrap piece of wood as backup under the workpiece,
This helps to reduce splintering and protects the point
of the bit,
DRiLLiNG METAL, ALUMINUM OR BRASS
NEVER hold the workpiece in your bare hands,
ALWAYS use clamps or vises to hold your workpiece,
Twist drill bits should only be used in drilling metals,
Never hold the workpiece in your bare hands, always
use clamps or vises, The drill bit may seize the work at
any time, especially when breaking though the work-
piece, if the workpiece is whirled out of the operator's
hand, the operator may be injured, The drill bit wiii be
broken if the workpiece strikes the column,
The workpiece must be damped or securely held in a
vise while drilling, Any tilting, twisting, or shifting results
not only in a rough hob, but also increases drill bit
breakage, For fiat work, lay the workpiece on a wooden
base and clamp it firmly down against the table to pre-
vent it from turning, if the workpiece is of irregular
shape and cannot be laid fiat on the table, it should be
securely blocked and clamped,
When drilling metal, it will be necessary to lubricate the
tip of the drill bit with oil to prevent it from overheating,
DRULUNG OPERATION
Use a center punch to dent the workpiece where you
want the hob, This will keep the bit from walking when
you start the drill operation, Before turning the drill
press ON, turn the laser ON and align the cross-hairs
with center mark on the workpiece, Make sure the
workpiece is properly supported or secured to the table,
For thru-drilling, make sure the table center hob is
aligned with the drill bit, Turn the drill press ON and
start to feed the drill chuck down with the feed handles,
FEEDING TOO PAPIDLY may cause the belt or drill bit
to slip or break, the motor to stall, the workpiece to pull
loose from the table, Never try to rush your work; allow
the drill press to work smoothly,
22