Advertisement
tVlodels with Ceramic
Glass
Cooktop
(continued)
Hot Surface
mndicator Lights
After using any of the radiant ebment positions the cooktop wiil become very hot. After turning
any of these ebments
OFF, the cooktop wili remain HOT for some time. The "Hot Surface"
indicator Hight w ili giow whenever any of the ebment positions becomes HOT. The Hot Surface
indicator Hightwili remain ON whib hot and turn OFF once the cooktop has coobd sufficbntHy.
ESEC Error
mndicator Message
(Er)
An error message wili be dispiayed (flashing "Er") at power up (or after a power failure) if ANY
of the surface controi knobs were bft in the ON positions (See Figure 1). If a power failure should
occur, be sure to set all of the surface control knobs to the OFF position. This will reset the
surface controls.
Once the su rface controls have been set to the OFF positions, the surface controls should return
to normal operation. If the surface controls do not function and the"Er" message remains in any
display after following these procedures, contact an authorized servicer for assistance.
ESEC Lockout
Feature
( - - )
The ESEC feature will not operate during a Seif-Cban
cycle. Whenever the ESEC Lockout
feature is active, " - - " will appear in any display window (See Figure 2).
Figure 1
Figure2
Operating
Single
Radiant
Surface
E_ements
(Mode_s
with
Ceramic
Glass
Cooktop
On_y}
The cooktop has single radiant surface elements at location as shown on figures 4 to 6,
To Operate
the Single
Surface
Emements:
1,
Place correctly sized cookware on the radiant surface element,
2,
_o
Push in and turn the surface control knob in either direction to the desired setting
(Figure 3), Turn the knob to adjust the setting if desired, Start most cooking operations
Sirn
on a higher setting and then turn to a lower setting to finish cooking. Each surface
2
element provides a constant amount of heat at each setting. A glowing red surface
heating area extending beyond the bottom edge of the cookware
indicates the
cookware is too small for the surface heating area.
3,
When cooking has completed, turn the surface control knob to OFF before removing
the cookware, Note: The Surface indicator light will come on when the control knob
wiii be turn on and wiii continue to glow until the glass cooktop has cooled down to a
moderate level, The light may remain on even though the controls are turned OFF,
Note: See page 9, Figure 1 for recommended control settings,
o©
Figure 4- Model B
Left & Right Rear
Elements
and Left front element
oo©
o
o
Figure 5 -Model C
Elements
and Left front element
%2
Figure 6 -Model D
Left & Right Rear Elements
and Left front element,
10
Advertisement
