Warm & Serve Drawer
To Remove Warm & Serve Drawer:
Turn power off before removing the warm & Serve drawer.
Open the drawer to the fully opened position.
Locate glide lever on each side of drawer, pull up on the left glide lever and
push down on the right glide lever (See Figure 1).
Pull the drawer away from the range.
To Replace Warm & Serve Drawer:
Pull the bearing glides to the front of the chassis glide (See Figure 2).
Align the glide on each side of the drawer with the glide slots on the range.
drawer open again to seat bearing glides into position. If you do not hear the
levers "click" or the bearing glides do not feel seated remove the drawer
and repeat steps 1 thru 3. This will minimize possible damage to the bearing
NOTE: The Warm & Serve D rawer will NOT operate while in the"Self-Clean" and
"Oven Lockout" modes
Electrical Shock Hazard can occur and result in
Disconnect appliance from electric power
before cleaning and servicing the warm & Serve drawer.
Pull up latch
Pull down latch