Sleep Mode; Timer Operation - Frigidaire FAC12C2ABJW Instruction Manual

SLEEP mode
Press the sleep button to activate the
sleep mode. To deactivate, press the
button again.
Cool only mode:
• The indoor unit fan operates at a
low velocity.
• After and hour of operation, the
adjusted temperature will increase
1° C. After, the unit keeps
operating 2°C above the adjusted
temperature.
In heating mode (some models):
• The indoor unit fan operates at a
low velocity.
• After and hour of operation, the
adjusted temperature will decrease
1° C. After, the unit keeps
operating 2° C below the adjusted
temperature.
Attention
Sleep function is only availaib[e in the
Coot/Heat and AUTO mode.
+l J-- J S,°o
E
e
SLEEP FUNCTION (Cooling mode)
oo
I
I
SLEEP FUNCTION (Heating mode)
TIMER Operation
TIMER button can set the auto-on time of the unit.
To set the starting time
1. Push the TIMER ON button, then the remote controller shows TIMER ON,
the last set time for the starting operation and the signal "h" will be shown on
the DIGITAL DISPLAY area. You are now ready to reset the time to START the
operation.
2, Push the TIMER ON button again to set desired unit start time,
3. After setting the TIMER ON ,there will be a one-half second delay before the
remote controller transmits the signal to the air conditioner. Then, after
approximately another 2 seconds, the signal "h" disappears and the set
temperature will re-appear on the digital display.