Operating
Instructions
The following instructions represent the Control Panel, the same instructions can be used for the Remote Control.
COOLING
MODE:
HEATING MODE:
(on some models)
DRY MODE:
AUTO
MODE:
FAN MODE:
In this mode the exhaust adaptor
hose lUST
be used.
1. Press the MODE button until the "Cool" indicator lights.
2. Press the " V A" Temp buttons for desired setting.
3. Press the FAN button for desired fan speed.
In this mode you do not need to use the exhaust
adaptor hose.
1. Press the MODE button until the "Heat" indicator lights.
2. Press the " V A" Temp buttons for the desired heat setting.
In this mode you do not need to use the exhaust
adaptor hose, BUT the water
collected must be discharged.
See Drainage
Section.
1. Press the MODE button until the "Dry" indicator lights.
2. The fan will run at low speed and the display will show the room temperature.
3. Keep doors &: windows closed for best effect.
Always have the exhaust
hose attached
in this mode.
When you set the air conditioner in AUTO mode, it will automatically select cooling,
heating(inapplicable
for cooling only models), or fan only operation depending on what
temperature you have selected and the room temperature.
The air conditioner will
control room temperature
automatically
round the temperature
point set by you. Under
AUTO mode, you can not select the fan speed.
TIMER
OPERATION:
SLEEP OPERATION:
In this mode there
is no need to use the exhaust hose or drainage
hose.
However,
if you require stale or smokey air to be removed from
the room,
hook up the duct accessories as described
in the "EXHAUSTING
HOT AIR"
section.
1. Press the MODE button until the "Fan" indicator lights.
2. Press the FAN button to choose the desired fan speed.
3. The fan will run at the selected speed and the display will show the room temperature.
You can set both delay stop and delay start while unit is in ON position or OFF position.
When unit is in ON position, first press TIMER button to go to delay stop setting, then
"timer off" light will illuminate, tap or hold the UP arrow (A) or the DOWN arrow (V) to
change delay stop timer at 0.5 hour increments up to 10 hours, then at 1 hour increments
up to 24 hours. Then press the TIMER button to confirm the setting (the control will confirm
the setting automatically
after 5 seconds) and go to delay start setting. Use the same way
as above to set the delay start timing. If you don't need to set delay start, press the
TIMER button again to exit. After 5 seconds, the control will automatically change the
display back to previous temperature display. If you want to check remain timing, press the
TIMER button. The delay start operation automatically selects mode, temperature and
fan speed the same as last operation you set.
When unit is in OFF position, press TIMER button will first go to delay start setting, then
"timer on" light will illuminate, set the delay start and delay stop timing the same way
as above.
To cancel the timer setting, simply tap (A) or (V) button to change the timing to 0.0.
In this mode the selected temperature
will increase by 2 °F 30 minutes after the mode
is selected. The temperature will then increase by another 2 °F after an additional 30
minutes. This new temperature will be maintained for 7 hours before it returns to the
originally selected temperature. This ends the "Sleep" mode and the unit will continue to
operate as originally programmed. The "Sleep" mode program can be cancelled at any
time during operation by again pressing the "Sleep" button.
Note: This feature is unavailabe under FAN or DRY modes.
02009 Electrolux Home Products, Inc,
All rights reserved.
#._