Page 1
Installation Instructions READ BEFORE INSTALLING UNIT DESIGNER SERIES Compact II Window Mounting "fOur air conditioner is designed to install in standard double hung windows with opening widths of 23 to 36 inches (584 mm to 914 ram) (FIG. 1) When handling unit, be careful to avoid cuts fronl sharp metal edges and ahlminum fins on...
Page 2
How to Install NOTE: Top Rail and Sliding Panels at each side are offset to provide the proper pitch to the rear of (5/16"). This is necessary for proper condensed water utilization and drainage. If you are not using the Side Panels for any reason, this pitch to tile rear must be maintained! Place unit on flooL\ a bench or a table.
Page 3
Place the frame lock between the frame Cut foam seal and insert in the space extensions and the window sill as shown between the ut)per and lower sashes (FIG, 13), (Fig. 8). Drive 3/4" (19 nun) locking screws through the frame lock and into the sill (FIG.