Led Worklight - Craftsman evolv 320.30856 Operator's Manual

LED WORKLIGHT (Fig. 9)
The LED worklight, located on Fig. 9
the base of the drill/driver, will
illuminate when the trigger switch ight
is depressed. This provides
additional light on the surface of
the workpiece for operation in
lower-light areas.
The LED worklight will turn off
when the trigger switch is released.
INSTALLING BITS (Fig. 10)
1. Remove the battery.
2. Lock the trigger switch by
placing the direction-of-
rotation selector in the OFF (center) position.
3. Open or close the chuck jaws to a point where the opening is slightly larger
than the bit size you intend to use.
4. Raise the front of the drill/driver slightly to keep the bit from falling out of the
chuck jaws.
5. Insert a drill bit.
NOTICE: Rotate the chuck body in the direction of the arrow marked GRIP to
close the chuck jaws. Do not use a wrench to tighten or loosen the chuck jaws.
6. Tighten the chuck jaws securely on the bit.
REMOVING BITS (Fig. 10}
Fig. 10 OPEN (release)
1. Remove the battery. Drill bit
2. Lock the trigger switch by
placing the direction-of- Keyless chuck
rotation selector in the OFF
(center) position. ;huck body
3. Open the chuck jaws.
NOTICE: Rotate the chuck body in
the direction of the arrow marked
RELEASE to loosen the chuck
jaws. Do not use a wrench to
tighten or loosen the chuck jaws.
4. Remove the drill bit.
_, WARNING: Make sure to
insert the drill bit straight into the chuck jaws. Do not insert the drill bit into
the chuck jaws at an angle and then tighten, as shown in figure 11. This could
cause the drill bit to be thrown from the drill/driver, resulting in possible serious
personal injury or damage to the chuck.
30856 Manual Revised 11-0623 Page 18