Table of Contents
Advertisement
LED WORKLIGHT
(Fig. 11)
The LED worklight
located on the base of the
drill will come on when the trigger switch is
depressed.
The LED worklight will turn off when
the trigger switch is released. This provides
additional
lighting on the surface of the
workpiece
for operation
in lower-light areas.
BiT STORAGE
(Fig. 12)
When not is use, the bit provided with the
drill can be stored on the base of the drill by
snapping
it into place in the bit clip.
Fig. t2
LED
worklight
Variable
INSTALLING
BITS (Fig. 13)
== Lock the trigger switch by placing the
direction
of rotation selector in the OFF
(center) position.
== Open or close the chuck jaws to a point
where the opening is slightly larger than the
bit size you intend to use. Also, raise the front
of the drill slightly to keep the bit from falling
out of the chuck jaws.
== Insert a drill bit.
NOTE: Rotate the chuck body in the
I
direction of the arrow marked GRIP to
close the chuck jaws. Do not use a wrench
to t ghten or oosen the chuck jaws.
J
m Tighten the chuck jaws securely on the bit.
REMOVING
BiTS (Fig. 13)
m Lock the trigger switch by placing the
direction
of rotation selector in the OFF
(center) position.
m Open the chuck jaws.
NOTE: Rotate the chuck body in the
I
direction of the arrow marked OPEN to
I
open the chuck jaws. Do not use a wrench
to t ghten or oosen the chuck jaws.
J
m Remove the drill bit.
Fig. 13
Ratcheting
Chuck
keyless
OPEN
chuck
jaws
(release)
Fig= t4
WRONG!
WRONG!
A.WARN|NG:
Make sure to insert the drill bit straight
into the chuck jaws. Do not
|
insert the drill bit into the chuck jaws at an angle then tighten,
as shown in figure
15.
J
This could cause the drill bit to be thrown
from the driJJ, resulting in possible serious
personal injury or damage to the chuck.
19
Hide quick links:
Advertisement
Table of Contents
