Lock - Fisher & Paykel DS601V2I-87550 Use & Care Manual

Start
/ Pause
I his button has a number of fimctions. It serves to:
* Start tile DishDrawer once tile desired wash program has been selected.
. Interrupt tile wash program while in operation.
I o pause tile DishDrawer, press tile Start/Pause button and wait until you
have heard two additional beeps before you open tile drawer, allowing the lid
sea[ to deflate. While in pause mode, tile light above tile Start/Pause button
will I]ash.
* Restart tile DishDrawer after being paused.
You may notice a delay after tile Start/Pause button has been pressed. During
this time tile lid seal will be inflating.
* One Button Start.
I his starts tile DishDrawer and will run tile last wash program used.
NOTE:
Under no circumstances do we recommend that you open the DishDrawer while in
operation unless you have pressed the Start/Pause button, ff tile drawer is opened
during tile wash program, there is a possibility of getting wet, burnt, or damaging tile
DishDrawer. I here are safety mechanisms in place to stop tile DishDrawer ff it is
opened.
I1 a red light appears above tile Start/Pause button, check tile secondary control panel
and note which lights are lit tip. I1 tile red lights above tile rinse and fast are [it this
indicates that tile door was opened during tile wash program. [o remove this fault,
ensure tile drawer is closed and press Power. [he DishDrawer will now be ready to
start from tile beginning of tile wash program. You may have to add more detergent in
tile dispenser and then press Start/Pause button to start the DishDrawer. I he
Dish Drawer will not restart where it was interrupted after a fault.
Lock
I he Lock fimction disables all tile other filnctions on tile
DishDrawer. I his fimction is useful when cleaning tile
control panel and can also prevent children from turning
tile DishDrawer on or off accidentally. I his button can be
used when tile DishDrawer is in operation and will remain
active until tile Lock is deactivated.
I o activate this function, press and hold tile Lock button
until tile red light above it appears continuously and is no
longer blinking. All tile other buttons are now inactive.
I o deactivate this fimction, press and hold Lock button
until tile red light above this button has disappeared.
Figure 2 - Display
showing the lock mode