Fisher & Paykel DS601V2I-87550 Use & Care Manual page 27

To Clean the Filter Plate
_, Ensure tile DishDrawer is cool before you start
cleaning.
• Remove tile drain filter and spray arm (see
previous instructions for their removal).
_, In the center of tile filter plate, there are two rings.
Hold tile center ring still and turn tile outer ring
counter clockwise, about a 'g turn. I his will
release tile filter plate.
_, When cleaning tile underside of tile filter plate,
care must be taken on tile sharp outer edge to
avoid tile risk of cut type injuries.
• Remove any soil, wash in hot soapy water and
rinse thoroughly in clean water. I he heater plate
can be wiped with a damp cloth.
_, Replace tile fi Iter plate so that it lies dat with tile
base of tile DishDrawer ensuring tile filter plate is
Iu[ly locked into position with tile outer ring. I o
lock tile filter plate into position, ensure tile
triangles (A) align with each other (see
Figure 22 for tile correct position). I he filter plate
must not be able to move about freely.
Figure 22 - Correct
Locking Position of Filter
Plate with Motor
Assembly
To Clean the Motor Assembly
I his area only needs to be cleaned under certain fault
conditions. Ihe IauJt code will appear on tile
secondary control panel and when you refer to tile
section on [atilt Code Displays, it will explain under
which conditions to clean tile motor assembly.
_, Follow tile above instructions for tile removal of
the drain filter, spray arm and filter plate.
_, I tim tile rotor-locking ring counter clockwise and
Figure 23 -
Motor Assembly
Key
1. Impeller
2. Rotor Locking Ring
3. Heater Plate
lift out. Once tile motor
Note:
assembly is lifted tip, check tile cavity for any foreign matter like bones or seeds
and rerllove.
Replace tile motor assembly back into tile small cavity in tile DishDrawer.
I urn tile motor assembly clockwise about '/8 oi a turn to lock into position.
I he arrows (/X) on tile rotor locking ring and tile motor housing must align
with each other (see Figure 23). I he motor assembly should not be able to be
lifted Lip freely. Carefully replace all tile other parts back into tile DishDrawer.
The DishDrawer must be used with the motor assembly, filter plate,
drain filter and spray arm correctly [n place.
Vacation Time
II tile DishDrawer is not going to be used for some time, we recommend you:
• Ensure tile baskets are empty.
_, Leave tile inside of tile DishDrawer clean.
• Leave tile drawers ajar to allow air to circulate.
• I urn offboth tile electricity and water supply to tile DishDrawer.
26