Lock - Fisher & Paykel DD602I Use & Care Manual

Start / Pause
This button has a number ofiunctions. It serves to:
• Start the DishDrawer once the desired wash program has been selected.
• Interrupt the wash program while in operation.
Fo pause the DishDrawer, press the Start/Pause button and wait until you
have heard two additional beeps beJore you open the drawer, allowing the lid
seal to deflate. While in pause mode, the light above the Start/Pause button
will flash.
• Restart the DishDrawer aJter being paused.
You may notice a delay aJter the Start/Pause button has been pressed. During
this time the lid seal will be inflating.
• One Button Start.
Fhis starts the DishDrawer and will run the last wash program used.
NOTE:
Under no circumstances do we recommend that you open the DishDrawer while in
operation unlessyou have pressed the Start/Pause button. If the drawer is opened
during the wash program, there is a possibility of getting wet, burnt, or damaging the
DishDrawer. There arc,salety mechanisms in place to stop the DishDrawc, r if it is
opened.
If a red light appears above the Start/Pause button, check the secondary control panel
and note which lights arc, lit up. If the red lights above the rinse and l_tstarc, [it this
indicates that the door was opened during the wash program. To rc, m ove this l_tult,
ensurc, the drawer is dosed and press Power. The DishDrawer will now be ready to
start from the beginning of the wash progr_tm. You may have to add more detergent in
the dispenser and then prc,ss Start/ Pause button to start the DishDrawer. Fhe
DishDrawer will not rc, s tart where itwas interrupted aJtera Jau[t.
Lock
fhe Lock function disables all the other Junctions on the
DishDrawer. This function is usetul when cleaning the
control panel and can also prevent children from turning
the DishDrawer on or off accidentally. Fhis button can be
used when the DishDrawer is in oper_ttion and will rc, m ain
active until the Lock is deactivated.
[o activate this Junction, press and hold the Lock button
until the rc, d light above it appears continuously and is no
longer blinking. All the other buttons arc, now inactive.
Fo deactivate this Iunction, press and hold Lock button
until the rc, d light above this button has disappearc, d.
Figure 2 -Display
showing the lock mode
9