Bagger Support Assembly; Mounting Cover Assembly To Support Assembly - Craftsman 917.249791 Owner's Manual

BAGGER SUPPORT ASSEMBLY
(See Figs. 1A & 1B)
NOTE: If your tractor already has four (4) shoulder bolts
installed on the rear drawbar, simply hang the support
assembly on the bolts. Discard the four (4) shoulder bolts
supplied and go on to Step 2 instructions.
SHOULDER
BOLTS
FIG. 1A
If your tractor does not have four (4) shoulder bolts installed
on the drawbar, follow the instructionsbelow.
1. Using the four formed holes in the drawbar, install the
four shoulder bolts as shown and tighten securely.
2. Hang the support assembly on the bolts.
SUPPORT LF
ASSEMBLY _ l _ TAPPING
SHOULDER
BOLTS
FIG. 1B
TO REMOVE THE SUPPORT ASSEMBLY (See Fig. lC)
1. Pulloutward on the stop bracket enough to allow support
assembly to be lifted up and away from drawbar.
PULL OUT ON STOP BRACKET TO
REMOVE SUPPORT ASSEMBLY
MOUNTING COVER ASSEMBLY TO
SUPPORT ASSEMBLY (See Fig. 2)
NOTE: For ease of assembly, you may wish to obtain the
assistance of another person for mounting cover assembly
to tractor.
1. Position cover assembly on ground behind tractor as
shown.
2. Lift and rotate cover to align cover bracket with support
assembly.
3. Slide cover assembly down ontothe support assembly.
COVER
ASSEMBLY
SUPPORT
ASSEMBLY
FIG. 2
FIG. lC 5