Advertisement
DRILLING
See Figure 11.
Fig. 11
When drilling hard smooth surfaces use a center punch
to mark desired hole location. This will prevent the ddll
bit from slipping off center as the hole is started.
The material to be drilled should be secured in a vise or
with clamps to keep it from turning as the drillbit rotates.
Place mode selector in drilling mode. Hold tool firmly
and place the bit at the point to be drilled. Depress the
switch trigger to start tool.
Move the drillbit into the workpiece applying only
enough pressure to keep the bit cutting.Do not force or
apply side pressure to elongate a hole.
,_
WARNING:
Be prepared for binding or bit
breakthrough. When these situations occur, drill
has a tendency to grab and kick opposite to the
direction of rotation and could cause loss of
control when breaking through material. If not
prepared, this loss of control can result in
possible serious injury.
When drilling metals, use a light oil on the drill bit to
keep it from overheating. The oil will prolong the life of
the bit and increase the drilling action.
If the bit jams in workpiece or if the drill stalls, release
switch trigger immediately. Remove the bit from the
workpiece and determine the reason for jamming.
_L
WARNING:
When servicing, use only identical
Craftsman replacement parts. Use of any other
part may create a hazard or cause product
damage.
Avoid using solvents when cleaning plastic parts.
Most plastics are susceptible to damage from various
types of commercial solvents and may be damaged
by their use. Use clean cloths to remove dirt, dust, oil,
grease, etc.
,_
WARNING:
Do not at any time let brake fluids,
gasoline, petroleum-based products, penetrating
oils, etc. come in contact with plastic pads. They
contain chemicals that can damage, weaken or
destroy plastic.
Do not abuse power tools. Abusive practices can
damage tool as well as workpiece.
Only the parts shown on parts list, page fifteen, are
intended to be repaired or replaced by the customer.
All other parts should be replaced by a qualified
service technician at an authorized service facility.
,_
WARNING:
Do not attempt to modify this tool or
create accessories not recommended for use
with this tool. Any such alteration or modification
is misuse and could result in a hazardous
condition leading to possible serious personal
injury.
13
Advertisement
