Install The Nt6D11Ab, Nt6D11Ae, Nt6D11Af Dchi - Nortel 1000 Installation And Commissioning Manual

Port Address
14
15
16-31
32-47
48-63
64-79
80-95
96-111
112-127

Install the NT6D11AB, NT6D11AE, NT6D11AF DCHI

Follow
(page 85)
Procedure 1
Install the NT6D11AB, NT6D11AE, NT6D11AF DCH
Step
1
2
3
4
Copyright © 2003-2007, Nortel Networks
.
Install the NT6D11AB, NT6D11AE, NT6D11AF DCHI 85
Half Group No.
S3 S4 S5
0 0 0
0 0 1
0 0 1
0 1 0
0 1 1
1 0 0
1 0 1
1 1 0
1 1 1
Procedure 1 "Install the NT6D11AB, NT6D11AE, NT6D11AF DCH"
to install the NT6D11 DCH on the Large System.
Action
Determine the cabinet and shelf location for the circuit pack being
installed.
The NT6D11AB, NT6D11AE, or NT6D11AF DCHI card can be
installed in any slot appropriate for an I/O port card on a Network
shelf. (The NT6D11 DCHI card can be located on the Common
Equipment shelf only on single-CPU switches.)
Unpack and inspect the card.
Set the option switches on the DCHI card. For PRA capability, set
port J2 to odd. For ISL capability, set port J2 for high speed or low
speed operation (See
programming jumper settings" (page
with ISL low-speed programming jumper settings" (page
Table 26 "Port address switch settings for ISDN" (page 84)
on Figure 36 "NT6D11 DCH with ISL high-speed programming
jumper settings" (page
Set faceplate toggle switch to DISABLE.
Nortel Communication Server 1000
ISDN Primary Rate Interface Installation and Commissioning
NN43001-301 02.03 Standard
Release 5.5 7 December 2007
Switch Setting
Device No.
S6 S7
1 1
Figure 36 "NT6D11 DCH with ISL high-speed
82), Figure 37 "NT6D11 DCH
82)).
S8 S9 S10
1 0 x
83), and
starting