Pri Messages; Dchi Quick Reference - Nortel Communication Server 1000S Maintenance Manual

Table 3
PRI commands (quick reference) (Part 2 of 2)
RMST loop
RMST l ch
RLBK loop
RLBK l ch
RSET l ch
SLFT loop
SLFT l ch
STAT
STAT loop
STAT l ch

PRI messages

DCHI quick reference

Perform self-test on loop.
Perform self-test on specified channel (2.0 Mb/s DTI/PRI
only).
Close loop at carrier interface point for testing.
Close channel ch at carrier interface point.
Reset thresholds for channel ch.
Invoke hardware self-test on loop.
Invoke partial hardware self-test on channel ch.
Get status of all loops.
Get status of DTI/PRI loop.
Get status of channel ch.
Refer to Software Input/Output: System Messages (553-3001-411) for
commonly encountered PRI messages.
The D-channel Interface (DCHI) card provides an asynchronous port and the
DCHI port. The D-channel performs the call setup and call modification
signaling for one or more 30-channel PRI cards. (Switch settings for the
DCHI port are shown in the DCHI replacement section.)
Quick reference to PRI operations
ISDN Primary Rate Interface
Page 27 of 210
Maintenance