Craftsman 126.32563 Operator's Manual page 6

ALWAYS wear Safety Goggles
(not glasses) that comply with
ANSI Safety standard Z87.1.
Everyday eyeglasses have only impact
resistant lenses.
They ARE NOT safety glasses.
Safety Goggles are available at Sears.
NOTE: Glasses or goggles not in compliance
with ANSI Z87.1 could seriously injure you
when they break.
13. WEAR A FACE MASK OR DUST MASK.
Sawing operations can produce dust.
14. SECURE WORK.
Use clamps or a vice to hold work
when practicable. It is safer than
using your hand and it frees both hands to
operate the tool.
19. CHECK FOR DAMAGED PARTS.
Before further use of the tool, a guard or other part
that is damaged should be carefully checked to
determine that it will operate properly and perform
its intended function - check for alignment of
moving parts, binding of moving parts, mounting
and any other conditions that may affect its
operation. A guard or other part that is damaged
should be properly repaired or replaced.
20. NEVER LEAVE THE TOOL RUNNING
UNATTENDED. TURN THE POWER "OFF".
Do not walk away from a running tool until
the blade comes to a complete stop and the
tool is unplugged from the power source.
21. DO NOT OVER-REACH.
Keep proper footing and balance at all times.
NEVER reach your arm or hand across the
path of the cutting blade.
15. DISCONNECT TOOLS FROM
POWER SOURCE before servicing, and
when changing accessories such as blades,
bits and cutters.
22. MAINTAIN TOOLS WITH CARE.
Keep tools sharp and clean for best and
safest performance. Follow instructions for
lubricating and changing accessories.
16. REDUCE THE RISK OF
UNINTENTIONAL STARTING.
Make sure switch is in the OFF position
before plugging the tool in.
23. WARNING: Dust generated from certain
materials can be hazardous to your health.
Always operate saw in well-ventilated area
and provide for proper dust removal.
17. USE RECOMMENDED ACCESSORIES.
Consult this Operator's Manual for
recommended accessories.
The use of improper accessories may cause
risk of injury to yourself or others.
18. NEVER STAND ON THE TOOL.
Serious injury could occur if the cutting tool
is unintentionally contacted.
I,_DANGER j
24. People with electronic devices, such
as pacemakers, should consult their
physician(s) before using this product.
Operation of electrical equipment in close
proximity to a heart pacemaker could cause
interference or failure of the pacemaker.
6