Advertisement
Available languages
Available languages
supplied). Use locking washers and nuts on
the underside of the workbench. (Fig. K)
I I
I I
I I
I I
I I
I I
I I
I I
(Fig. K)
washers, nuts, etc. to the underside of the
plywood mounting board to avoid an uneven
work surface.
3. Use 'C'- clamps to attach the mounting
board to the work surface. (Fig. L)
1. Tighten the miter and bevel locks.
See OPERATION section.
ADJUSTMENT
INSTRUCTIONS
2. To avoid injury from flying dust, position
the saw so that other people or bystanders
cannot stand too close (or behind) it.
3. Locate the saw on a firm, level surface
where there is plenty of room for handling
and properly supporting the workpiece.
4. Support the saw so the machine table is
level and the saw does not rock.
5. Bolt or clamp the saw securely to its
support stand or workbench.
For portable use:
1. Mount the saw on a % in. thick piece of
plywood using appropriate fasteners
(not supplied).
2. It may be necessary to countersink the
1,_
WARNING
j
To avoid injury from electric shock or
from an accidental start, make sure the
switch is in the OFF position and the plug
is not connected a power source outlet.
NOTE: When checking angular
alignments the Cutting
Head should be
lowered and locked in the down position
with the latching pin fully located in its
socket.
Refer to 'Locking
the Cutting Head in the
Down Position' page 18.
0° Bevel Stop Adjustment
1. Ensure that the Cutting Head is upright
against its stop and the Bevel Pointer is
indicating
0° on the scale.
22
Advertisement
